Countersinks conversion to Pro-E

[MartB]

HELP.. I need somebody Help, not just any body Help.
When I convert from SolidWorks 2001 to Pro-E I cannot unbend my sheetmetal parts once they are in Pro-E when they have countersinks.I have tried different things. Even making countersinks with a hole and a cut extrude with a draft angle. I'm THAT desperate. Is there anybody out there with a solution.

Thanx a million.

Marty

 

[SBaugh]

Marty,

Go to comp.cad.solidworks newsgroup. Someone there can help you better, since no one replied to your post here.

Also check out

http://www.topica.com

&

http://www.mechengineer.com/snug

These are two very good threaded sites if you have to deal with a firewall and can't get to a newsgroup.

Hope that helps,
Scott Baugh, CSWP
George Koch Sons,LLC
Evansville, IN 47714
sjb@kochllc.com