Courses on ASME VIII Div 2 3

[SphericalHead]

Are there any good courses on ASME VIII Div 2 part 5, specifically with regards to ensure code compliance using design by analysis.
All the courses I've come across focus only on the the actual FEA analyses and not converting the FEA result to a suitable code compliance report/calculation. Specifically stress categorization.
Courses are presented as "Finite element analysis of pressure vessels" but focus very little (less than 30 minutes) on ASME stress criteria and focus more on using the software more than anything else.

Thanks.

 

[IdanPV]

I heared very good things about BECHT Course: ASME Section VIII, Division 2 – Part 5, Design-By-Analysis
You can see the course content on BECHT website.

The course will be held Virtually and in Alberta on March 17-20, 2025 and in The Hague on June 30 - July 3, 2025.
The instructor is Mr. Trevor Seipp, which participate in this forum as well.

 

[jmec87]

BECHT Course: ASME Section VIII, Division 2 – Part 5, Design-By-Analysis
You can see the course content on BECHT website.

The course will be held Virtually and in Alberta on March 17-20, 2025 and in The Hague on June 30 - July 3, 2025.
The instructor is Mr. Trevor Seipp, which participate in this forum as well.

I've taken this course from Mr. Seipp and I thought it was good.

 

[RJW000]

I heared very good things about BECHT Course: ASME Section VIII, Division 2 – Part 5, Design-By-Analysis
You can see the course content on BECHT website.

The course will be held Virtually and in Alberta on March 17-20, 2025 and in The Hague on June 30 - July 3, 2025.
The instructor is Mr. Trevor Seipp, which participate in this forum as well.

I’ve taken this course years back, highly recommended if you are interested in Design-By-Analysis.

 

[TGS4]

I heared very good things about BECHT Course: ASME Section VIII, Division 2 – Part 5, Design-By-Analysis
You can see the course content on BECHT website.

The course will be held Virtually and in Alberta on March 17-20, 2025 and in The Hague on June 30 - July 3, 2025.
The instructor is Mr. Trevor Seipp, which participate in this forum as well.

I'd be happy to have you join us either virtually or in Calgary in March, or in The Hague at the end of June/early July. I'm not sure where you are physically located. If it's convenient for you, I would suggest the in-person option. However, the virtual option in March is also very accessible - although from a schedule perspective, I need to note that it goes from 9am-5pm MDT (UTC-06:00), so if you are not in North America, the time can be challenging. Nevertheless, I have had virtual course attendees from Europe, the Middle East, and even India.

I hear you about wanting to understand the ASME Code rules to ensure Code compliance. That's essentially exactly what my course covers.