Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
creat threads in pro-e
- Thread starter PROCON
- Start date
Use the Helical Sweep feature.
1-Create the bottle and the neck where you will place the threads.
2-Select Feature/Helical Sweep and right-or left hand (your choice), and Constant or Variable thread.
3-Create the axis or revolution for the center, and make the profile sweep path along one side of the bottle neck. Use Edge for this in sketcher.
4-Create the thread profile as required.
5-Enter the Picth Value (threads-per inch...).
Hope this gets you started.
Steve
1-Create the bottle and the neck where you will place the threads.
2-Select Feature/Helical Sweep and right-or left hand (your choice), and Constant or Variable thread.
3-Create the axis or revolution for the center, and make the profile sweep path along one side of the bottle neck. Use Edge for this in sketcher.
4-Create the thread profile as required.
5-Enter the Picth Value (threads-per inch...).
Hope this gets you started.
Steve
- Status
Similar threads
- Locked
- Helpful tip