Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Create a hole by intersecting shells in SAP2000

Thread starter benjaminlafarga
Start date Jan 31, 2014

Status: Not open for further replies.

Jan 31, 2014

benjaminlafarga

Structural

Hello everybody.

I am designing an intersection between one roadway tunnel and one cross passage. Both are curved surfaces modeled with longitudinal direction shells. Does exist any procedure to intersect these surfaces so I can create that hole in SAP2000. I know in SCIA is possible with the option "end cut" but I found nothing similar in SAP2000.

Thanks a lot!

Benjamin