Apr 9, 2009 #1 Runz Aerospace Oct 3, 2005 216 0 0 US When creating CATParts from CATProducts, we have noticed some gaps/voids in the 3d geometry. Is there a setting or a way to eliminate or fill these voids? Thanks,
When creating CATParts from CATProducts, we have noticed some gaps/voids in the 3d geometry. Is there a setting or a way to eliminate or fill these voids? Thanks,
Apr 10, 2009 #2 itsmyjob Mechanical Apr 11, 2002 2,375 0 0 CA Hello, You are talking about gaps/voids... you are missing geometry in the CATPart? Did you check if all solids in the CATProduct are updated? Eric N. indocti discant et ament meminisse periti Upvote 0 Downvote
Hello, You are talking about gaps/voids... you are missing geometry in the CATPart? Did you check if all solids in the CATProduct are updated? Eric N. indocti discant et ament meminisse periti
Apr 11, 2009 #3 1oldcaduser Automotive Jun 3, 2005 79 0 0 SE What are you using the created parts for? The parts from product creates a dead part. Are you sending it to another system Upvote 0 Downvote
What are you using the created parts for? The parts from product creates a dead part. Are you sending it to another system