Create curves and points in drafting without sketch NX6

[cmacca]

I would like to add points and curves to a drafting sheet but all curve and point commands in NX6 creates a sketch. In NX5 you could create curves and points and have the option to create them in a sketch or not. Is this possible in NX6?

I have templates created in NX5 that have curves created without sketches. They have now been converted to NX6, I can copy the sketchless curves but I now need to add a point and there are no sketchless points to copy in my template.

NX 6.0.1.5, TC 2007

 

[JohnRBaker]

At least in NX 6.0.2.x, you will be able to create points and curves, with or without using a Sketch, on the face of a drawing.

John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.