Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Creating a pattern of a surface or volume region

Thread starter gpommer1
Start date Jul 16, 2012

Status: Not open for further replies.

Jul 16, 2012

gpommer1

Agricultural

I'm wondering if it is possible to pattern a series of volume or surface regions rather than manually creating each region? I have a bolt pattern that I am attempting to constrain by creating surface regions that represent the cone of compression for the bolted joint. I haven't been able to find a better way that manually creating each surface region at each bolt instance.

Thanks.