Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

creating realistic bend or flex in hot worked collet finger

Status
Not open for further replies.

johnchrc

Mechanical
Jul 14, 2004
176
US
We induction heat a Flex Seat so collet fingers are hot enough we can hot work to size. I don't know how to model this in Solidworks. I have attached a JPEG of a section view of the flex Seat. We don't even show it flared in our drawing. I want to draw this flared at fingers about their neutral axis until I reach 4.882 OD at tip of fingers.

Does anyone know how the best way to tackle this modeling problem? Of course I can simplify and make one part.

Any good resources on the web that could provide help?

Thanks

- CJ
 
 http://files.engineering.com/getfile.aspx?folder=028dbee5-3f52-429b-801d-71ec2ca37da6&file=Flexible_Seat.JPG
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top