Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

creating sketch geometry within the drawing

Status
Not open for further replies.

SolidCreative

Mechanical
Jul 27, 2004
143
Is it possible to create sketch geometry within the drawing? I want to sketch circles and lines to show reference information, like when showing clearances for things that revolve around a pivot for example. I am able to create the sketch, but am not able to mate it to any drawing lines, and the project geometry option is grayed out.
 
Replies continue below

Recommended for you

You need to select the view first then click sketch, then you should be able to project geometry from that view.
 
Thanks you very much! I figured it was possible, but had not tryed that option
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor