Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Creating surfaces and not CGR's from Swept Volumes

Thread starter spartan2674
Start date May 23, 2010

Status: Not open for further replies.

May 23, 2010

spartan2674

Automotive

Hello,

I use the Swept Volume option in DMU Kinematik to create a swept volume of a mechanism's replay.

The end result is only a CGR file/s. Is there any way, where I could create the swept volumes as CATIA surfaces ? The CGR files are really not workable with.

"Das Beste Oder Nichts"