Cropping an Iso View

[djw2k3]

Hi,

Have just drawn a closed spline to crop an isometric drawing view.

Get the error "This view cannot be unfolded any further"

First time I have ever seen this error. Any ideas out there??

Thanks in Advance

Dave

 

[djw2k3]

ops, using SW2001+

 

[djw2k3]

bump

 

[SBaugh]

I have tried making a crop view of an Isometric view in both SW03 and SW01+ and it worked fine in both. (SW01+ SP6)

Is this a sheet metal part that you trying to crop?

Try croping say the front view or side view and see if that works.

Try making a new drawing and placing that part in there and see if you can crop it there.

Regards,


Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376
When in doubt, always check the help

 

[djw2k3]

Hi Steve,

Yeah this is the first time I have ever had this problem with cropping a view - Its of an assembly ~500 Parts, am running SW01-SP6, will have another play at some stage and see if I can find the prob.

djw