Crown Gears

[PaulD76]

Hello,

I am looking for a supplier of crown gears in Ireland or UK. I looked up HPC gears and ondrives but they dont seam to do them.
Torque is too high for derlin etc need a steel version.

Thanks

Paul

 

[gearcutter]

Why crown gears?
Wouldn't you be better off using a bevel set?

Ron Volmershausen
Brunkerville Engineering
Newcastle Australia

http://www.aussieweb.com.au/email.aspx?id=1194181

 

[PaulD76]

A crown gear fits better with my design. I have seen a old car jack that use a sheet metal type crown gear, seams as it was blanked out and drawn. Cost is also a issue, I'm hoping this type of crown gear would be under 5 euro? For a large qty.