Hello,
I am trying to view the table for "Strip Forces - Enveloping Summary" for a combined footing model. Since I am accounting for uplift, I had converted all of my load combos to Non Linear load cases. Thus, I have over a thousand Non Linear load cases to run. I was able to run the analysis, although it did take quite a long time - perhaps 15 minutes. However, when trying to view shear and bending forces in the footings, the table takes very long to load - more than an hour.
I'm curious if anyone has had this experience, and if there are any tips to overcome this issue or circumnavigate it. Or do I just need to wait?
Thanks!
I am trying to view the table for "Strip Forces - Enveloping Summary" for a combined footing model. Since I am accounting for uplift, I had converted all of my load combos to Non Linear load cases. Thus, I have over a thousand Non Linear load cases to run. I was able to run the analysis, although it did take quite a long time - perhaps 15 minutes. However, when trying to view shear and bending forces in the footings, the table takes very long to load - more than an hour.
I'm curious if anyone has had this experience, and if there are any tips to overcome this issue or circumnavigate it. Or do I just need to wait?
Thanks!
