Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

CST smith chart

Status
Not open for further replies.

antenna9071

Electrical
Jun 17, 2011
8
When I have done a parameter sweep in cst I usually look at the S11 parameter. If I got 2 curves at the S11 figure simulated by the parameter sweep. How did I get both curve into the same smith chart.

/Thomas
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor