AntoineD
New member
- Dec 6, 2012
- 1
Dear all,
The problem I’m currently facing with coordinate systems (Csys) is the following:
- During pre-processing a Csys different from the model’s main Csys is created at a specific position.
- During post-processing , the origin of this different Csys becomes the same than the model’s main Csys origin.
I've been through the documentation and found nothing on this matter. The only solution I have now is to create again a Csys in the .odb file.
My questions are:
- in a Model, if a Datum Csys is created at a specific position as a feature at Assembly or Part level, how is it possible to recover it at its initially defined position in the .odb file for post-processing purposes?
- is it possible to write in the .inp file the origin and axes of this different Csys?
Thanks in advance for your support!
Antoine
The problem I’m currently facing with coordinate systems (Csys) is the following:
- During pre-processing a Csys different from the model’s main Csys is created at a specific position.
- During post-processing , the origin of this different Csys becomes the same than the model’s main Csys origin.
I've been through the documentation and found nothing on this matter. The only solution I have now is to create again a Csys in the .odb file.
My questions are:
- in a Model, if a Datum Csys is created at a specific position as a feature at Assembly or Part level, how is it possible to recover it at its initially defined position in the .odb file for post-processing purposes?
- is it possible to write in the .inp file the origin and axes of this different Csys?
Thanks in advance for your support!
Antoine
