Custom Hole wizard profiles

[btcoutermash]

When you add a custom profile for a tapped hole to the hole wizard custom data base, how do you get the callout to show on the print when you use "Add a hole callout" command??

 

[SBaugh]

SPR 231247 - Thread type, depth, and size is missing from hole callut for derived standards.

Till this is fixed you have to do it manually.

FYI - You did place the data in your "Thread data" DB and not just under Hole wizard... didn't you?

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

If you are in the SW Forum Check out the FAQ section

To make the Best of Eng-Tips Forums FAQ731-376

 

[btcoutermash]

Yes i did place the info in "thread data".

 

[SBaugh]

Then see the above SPR.

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

If you are in the SW Forum Check out the FAQ section

To make the Best of Eng-Tips Forums FAQ731-376