Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Custom iProperties in Drawing BOM

Thread starter automationbabe
Start date Dec 1, 2009

Status: Not open for further replies.

Dec 1, 2009

automationbabe

Mechanical

I created an iAssembly with multiple configurations. The assembly contains two iParts that vary in length. I'm trying to display the BOM to show all the configurations. It works beautifully until we get to the Custom Tab iProperties that also need to be displayed in the BOM for the individual iParts. I can only get the active configuration to show, and all the others remain blank.

Is there something I'm missing? Do I need to flag the custom fields somehow in the iPart table so they appear in the iAssembly BOM? Please help. All the searches I've done has turned up nothing.

I'm using R11 with all the latest patches. If this is resolved in a newer release, please let me know as we are finally upgrading.

Thank you.