Custom program in NX for getting flat length model of cable

[NXsupport]

Hi,

N10 and going to NX12.. Does anyone know of custom program ( Journal / Macro / NXopen ) to get flat length solid model from routed cables? Iam looking for similar program as in NX sheet metal / Flexible Printed Circuit Board module , where I do the install flex or bent sheetmetal component and I click Flat solid and NX makes a flat solid..

Any help is much appreciated..

 

[Toost]

In Routing Electrical + Harness there is an application for this. Its called "Form board" and will produce what you are looking for.

Regards,
Tomas

 

[NXsupport]

Sorry Toost, I dont have access to the license.. So I was looking for some kind of ugopen program or journal ..

Iam sure some one might have developed it.