Cut-back length for line pipe

[CoCoE]

What is the standard length we should leave as cut-back length for a line pipe?

Is there any standards referring this? If yes, please help.

Regards

kRishn4

 

[brpillai]

Cut back length is of 150 mm ± 20 mm unless normally. At the cutback, the coating edge shall be shaped to form a bevel angle of 30° to 45°. For stainless steel pipes, non-ferrous or stainless steel tools shall be used.

 

[CoCoE]

Brpillai,

Thank you for the reply. But here I am looking for any standards which is mentioning it. We do follow similar as you have specified.

Cococa