Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cuts through a toroid

Status
Not open for further replies.

StephenDD420

Electrical
Jun 12, 2013
1
Hello all,

I am having some trouble cutting holes through my toroid at different angles.

I created my toroid by creating a reference axis from the origin to the front plane, then selecting the top plane. I then created a square 2 inches from the origin point, exited the sketch and revolved base around the reference axis.

What I am trying to do now is cut holes through the toroid from the center outward through the inner side of the toroid every 30 degrees. How can I accomplish this?

Thanks in advanced for any help anyone can give me.
Stephen
 
Replies continue below

Recommended for you

Oops, just re-read your post and saw the "every 30°" need.

After creating the first hole with the Hole Wizard, use the Circular Pattern to create the others.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor