Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

CWALSHT

Status
Not open for further replies.
jrm81

jrm81

Civil/Environmental
Dec 5, 2017
1
I'm using CWALSHT to design an anchored sheet pile and everything works out fine for the "design" parameters. When I enter in sheet pile data (depths, E, I) for the “analysis” option, I get the attached error saying that "Wall bottom has been specified above the soil surface." This isn't the case though. Wall bottom is set at 1055. Left surface set at 1062 and right surface set at 1075. My soil layer data goes well below the bottom of the wall too. Any ideas what I'm doing wrong?
 
 http://files.engineering.com/getfile.aspx?folder=327445e4-0947-4313-a574-6706737c4e3b&file=Capture.JPG
Status
Not open for further replies.

Similar threads

MJ23struct
  • Locked
  • Question
CWALSHT
Replies
2
Views
65
vulcanhammer
vulcanhammer
BigEasyGeoSleuth
  • Locked
  • Question
Anchored Sheetpile Wall Design (CWALSHT)
Replies
3
Views
88
Touma59
Touma59

Part and Inventory Search

Sponsor

Back
Top Bottom