Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cyclic Plasticity

Thread starter Ram28
Start date Feb 20, 2006

Status: Not open for further replies.

Feb 20, 2006

Ram28

Materials

Hi ABAQUS users,

I have been trying to run an cyclic plasticity model using the ABAQUS v6.4. However, I am not completely convinced with the description given in the manual on the procedures to obtain the hardening parameters. I am trying to figure the right way to use the mixed hardening. If there is anyone experienced in this area please give me your helping hand.

Ram