D1.1 code book 2010 version

[dbernard2012]

RE; Table 2.9. Can someone explain this table? question below.

Question : What is the Z loss dimension for pre-qualified PJP T-,Y-K-
Connector what a groove angle of 50 degrees using short circuiting transfer GMAW in the horizontal position?

 

[dbernard2012]

Hey Fellas, waiting on a response?

 

[gtaw]

Did you look at the clause and the figures that are referenced? The figures on the last page of clause 3 pretty much says it all.

Best regards - Al