Ranulfo Martins Carneiro Neto
Mechanical
- Jun 4, 2017
- 3
Hi everyone!
Is there any way in Abaqus to represent the deepth?
In my work it would be a deepth of a adhesive joint (attached). For this arrangement, there are many possibilities about deepth value, that certainly would get influence in the joint behavior.
Best regards.
Ranulfo
Is there any way in Abaqus to represent the deepth?
In my work it would be a deepth of a adhesive joint (attached). For this arrangement, there are many possibilities about deepth value, that certainly would get influence in the joint behavior.
Best regards.
Ranulfo