paulpatrick
Mechanical
- Aug 27, 2005
- 49
Hi
Was wondering if any one can recommend a good tutorial on setting up the Config options file for proE?
Ones I have had to change e.g.
Angle of projection to First angle
decimal places displayed when dimension is annotated first so that its to one decimal place.
How do you set it so it reads this file on program boot up!
Where can get a list of the config options explained?
regards
paul
Was wondering if any one can recommend a good tutorial on setting up the Config options file for proE?
Ones I have had to change e.g.
Angle of projection to First angle
decimal places displayed when dimension is annotated first so that its to one decimal place.
How do you set it so it reads this file on program boot up!
Where can get a list of the config options explained?
regards
paul