optimus2007
Mechanical
In Abaqus it is possible to define sets. As far as I am informed
you need this sets for creating boundary conditions and defining loads, pressure.
What makes me confused is that you can define a set in "Part"
and on he other hand in "Assembly", where you find the defined set from the Part too.
So what is the difference? Is it better only to define it in Assembly module?
thanx
you need this sets for creating boundary conditions and defining loads, pressure.
What makes me confused is that you can define a set in "Part"
and on he other hand in "Assembly", where you find the defined set from the Part too.
So what is the difference? Is it better only to define it in Assembly module?
thanx
