Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Defining data surface with results set

Thread starter mvitezic
Start date Oct 14, 2004

Status: Not open for further replies.

Oct 14, 2004

mvitezic

Mechanical

Hello!

I'm using I-deas 10 NX Series. I have following problem: I want to define data surface on a surface by using imported result set. I-deas is reporting error (Number of defining points should be within 4-40000). Does anyone have expirience with this type of problem?

Thanks

Marin