Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Deformation of environmental seal ADVICE

Thread starter hawkgt
Start date Nov 19, 2014

Status: Not open for further replies.

Nov 19, 2014

hawkgt

Automotive

I am needing to create environmental seals of various profiles in a manufactured state and also representative of a compressed state typically against a curved glass surface.
I have looked into Global Deformation and Shape Deformation but I am not sure if this is the best approach.

Any advice I can get will be greatly appriciated.

Thanks in advance.

Peg

NX8.5