Deleting Pro/I Reference

[atlarson]

I created a Pro/E interchange assembly to swap out a large number of fasteners in my "product" assembly. This replacement was a one-time design change - I will never use the interchange assembly again. However, when I attempt to check the product assembly into Pro/Intralink, I am required to check the interchange assembly in also. Is there any way to break the link between the two so that the interchange assembly can be deleted? I am running Pro/E 2001, and Pro/I version 3.2.

Thanks,
Andy

 

[3dlogix]

Make sure that in the assembly mode, you pick SET UP > INTERCHANGE and REMOVE. This deletes any references to the assembly interchange model.

Steve

http://www.sprdesign.com

http://www.3dlogix.com