Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dents

Status
Not open for further replies.
mithuntech

mithuntech

Mechanical
Jan 21, 2013
4
0
0
AE

References
For pipelines under ASME B31.4, Clause 434.5.
For pipelines under ASME B31.8, Clause 841.2.4(c).

Query
Both the referred clauses specifies dent as a percentage of nominal pipe diameterfor pipe diameter greater than 12".
Please could you confirm whether it is referring to nominal outside diameter

Regards,

 
Replies continue below

Recommended for you

Sort by date Sort by votes
Above 12" nom pipe size in inches and OD are the same thing so yes, I would go for OD.

Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Dario2002
  • Locked
  • Question
Tool for measure dents
Replies
1
Views
2
Rich2001
Rich2001
mohd
  • Locked
  • Question
GOUGE & DENTS
Replies
3
Views
4
ralphsare
ralphsare
Back
Top