Dependencies/Details/Preview panes in Part Navigator disappeared in NX10

[longroadtrip]

In NX 10, the dependencies, details and preview panes have disappeared from the bottom of the part navigator. They are still there in assembly navigator.
Is there a setting to turn them back on? I have tried deleting the setting folder from the appdata folder, but that did not fix them problem.

thanks for your help

 

[cowski]

Do you see a line of dots near the bottom of the navigator (under the scroll bar, if one is displayed)? If so, mouse over the dots until the cursor turns into a double headed arrow, then click and drag it up. The other panes of the navigator will reappear.

www.nxjournaling.com

 

[longroadtrip]

Thanks cowski, that was the problem. I had tried that but because one of the panes was "open" you need to drag it a lot further before it does anything.