DNod8
Structural
- Dec 18, 2015
- 11
Dear All,
I have a problem on how to connect the new rc ledge which is roughly 1350mm cantilever from the brickwall. The building is an existing structure. Usually in my design, for any building that have cantilever canopy or ledge, I will make sure it connects to my beam because I am afraid of pulling force that will exert on the brickwall as I do not study design for this.
However, this situation did not allow me to put my rc ledge at my 1st floor beam.
Any suggestion on how to tackle this?
Please find attached the image of the issue. Thank you.
a novice in engineering who wants to learn and learn
I have a problem on how to connect the new rc ledge which is roughly 1350mm cantilever from the brickwall. The building is an existing structure. Usually in my design, for any building that have cantilever canopy or ledge, I will make sure it connects to my beam because I am afraid of pulling force that will exert on the brickwall as I do not study design for this.
However, this situation did not allow me to put my rc ledge at my 1st floor beam.
Any suggestion on how to tackle this?
Please find attached the image of the issue. Thank you.
a novice in engineering who wants to learn and learn