Design Scenario not changing values

[sloth4z]

I made a design scenario with 4 sets for a frequency study. In each set I changed two dimensions. (3/16, 1/4; 3/16, 2; 1/4, 1/4; 1/4, 2). I ran the scenario but the results were all the same. I don't get it because I just finished running a seperate design scenario with different changes that worked fine.

 

[sloth4z]

I figured it out. I was running the study on an assembly and the active part configuration was not the one used in the active assembly configuration. That means that the dimensions of the part did not change between sets.