I am designing a 4 mw furnace to fire woodchip (h.v 2800 kj/kg,moisture 30%)to supply heat for a steam generator.The furnace is step-pushed-grate.Grating ares is 5.2 sq,m. 1.3m width 4m lomg The incline angle is 15. Upper part of the furnace is watercool wall.Lower part is firebrick wall.Every suggestion for this design are welcome.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
design tip for step-pushed-grate
- Thread starter aaaaaaa
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question