Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Design to ASME Div1.

Status
Not open for further replies.

vesselpv

Mechanical
Joined
May 23, 2006
Messages
7
Location
CA
Small 2 " ID cylinder is subjected to 6500 psi of Matl Aluminimum is being designed per ASME SEction VIII Div.1. ASME U-19(j) allow use of Div.1 above 3000psi with additional design principles and consturuction practice for higher pressure.

My question is what are these additional design requirements and what section of the ASME Div.1 defines that additional requirements.
 
The AI will require this to be designed to Div 2 and he/she is doing you afavor you can stamp it in Div 1,
most AI will not allow it but it is permitted by the Code.
genb
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top