Design View and Positional Representations...

[MechCT]

I apologize if this topic has been covered recently, but I couldn't find it and the seach function on this website isn't working at the moment.

In any case, I've excluded a spring from my design view representation (DVR) and I've modified the mate offset for a screw with my positional representation (PR), but for some reason, I cannot figure out a way to enable them both at the same time without setting my DVR and PR to the desired state seperately... Is there a way that I can set up either the DVR or the PR to enable all of the changes I want? Is there a way to link the two representations so that just clicking one will activate both assembly view modifications?

Thanks.

 

[SeanDotson]

No not currently. We have asked for a Global Rep that will control both DV and PR. Hopefully in a future release.

Sean Dotson, PE
RND Automation & Engineering

http://www.rndautomation.com