Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

DesignModeler Question 1

Status
Not open for further replies.

Stringmaker

Mechanical
Mar 18, 2005
513
I have a parasolid body that I import into designmodeler. My experience lies completely within Ansys and I'm trying to block to cut this part up into sweepable blocks so that i can get hex mesh the part. My question is how can I cut this part up in DM? I've figured out how to creat lines from edges on the body but I can't figure out how to extrude these lines in a particular direction to form areas which I can then cut the volume by. Could anyone help me with the bottom up procedure on how to execute this task? I'm pretty clueless and so far the DM help hasn't proven to helpful. I've tried slice operations but I don't want to cut the body by a certain plane.

Thanks in advance for your help,
-Brian
 
Replies continue below

Recommended for you

Brian,

You can slice by sketches if you want. In order to do this, make sure all bodies are frozen. Then, sketch your 2D drawing of what you want to slice by, then extrude it. Then, change the operation to be slice material instead of add material. You can also select which bodies you want the slice to go through.

So what you should do is:

1 - Freeze all bodies
2 - Sketch your 2D drawing of what you want to slice by
3 - Extrude, change operation to slice material

There are some good articles on DM basics at:


Good luck
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor