diagnostics keeps poping up when open iges

[oldboot]

when I open an .iges file (saved-as iges by pro/e) with solidworks.

a diagnostic windows pops out see picture link below.

<img src="

http://tinypic.com/i2ua6w.jpg">

I did seleck "always ask me this", then it always pops this message and creat solidworks part file for every single component. that is really annoying.

Does anyone know how to turn off this?

I tried the help file but there is no this tool in my software.

<img src="

http://tinypic.com/i2ucu9.jpg">

any help or suggestion would be appreciated.

 

[PDMAdmin]

Try going under "Tools / Options / Default Templates." Make sure your default template file locations are specified there, then choose "Always use these default document templates." That's what worked for me when I had the same issue.

 

[oldboot]

thanks you very much.

It is as you said.

anyway, when I open other iges files, it does not. Maybe only that part I did the settings keeps annoying me.

I also searched out & read the thread you discussed before.

Thanks for you kind help.