different fonts in same text string

[Yogibear]

Didn't see this anywhere.
Is there a way in 2d to put in text and symbols in the same text block. We've imported some ACAD drawings over to SW and if I have text-symbol-text-symbol-text I loose the middle text and I don't know how they got the symbol after the text because I am not able to do it.
Thanks.

 

[ctopher]

If its symbols you want to add to the text, right click on the text string, properties, click where you want the symbol and insert the symbol. Hope this is clear.

 

[Yogibear]

My bad. I should have said text-different font-text-different font. . .

 

[CajunCAD]

It appears to me that this is a limitation of SolidWorks. From what I have found only one font / font size is permitted per annotation.

 

[SBaugh]

You could insert a Microsfot Word Document. Then you have full control over your text.

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376