shiraz883
Automotive
- Nov 15, 2006
- 48
Hi,
I am running a static 2d axisymmetric analysis in different versions of Ansys and getting different results wrt deformation and stresses although everything is the same - model, boundary conditions, loads etc.
I am using APDL for the analysis. Just for information a legacy element BEAM 3 is used. Does it affect the results in 2021 vs 2022?
Thanks
Shiraz
Sr. Engineer
I am running a static 2d axisymmetric analysis in different versions of Ansys and getting different results wrt deformation and stresses although everything is the same - model, boundary conditions, loads etc.
I am using APDL for the analysis. Just for information a legacy element BEAM 3 is used. Does it affect the results in 2021 vs 2022?
Thanks
Shiraz
Sr. Engineer