Dimension constraint Max and Min?!?

[jiminycricket]

Hello all,

I'm struggling with an expression within assembly constraints on NX6 (6.0.3.6).

I'm trying to set a max and min on a dimension constraint rather than being a set at a constant. This is so I can set a movement sequence and check for collisions within the machine. I'm sure it's exceptionally simple but I seem not to be able to get the syntax correct...very frustrating!

Thanks in advance for any help.

Cheers,

Ben

 

[SiW979]

can you post an example of the expression that you are getting the error with?

Best regards

Simon NX4.0.4.2 MP10 - TCEng 9.1.3.6.c - (NX6.0.3.6 MP2 native)

http://www.jcb.com

Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...