Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

dimension start resetting to 0,0

Thread starter marize
Start date May 16, 2011

Status: Not open for further replies.

May 16, 2011

marize

Structural

Hello,
We are having a problem with dimensioning. Dimensions are placed and drawings saved, but after a close and reopen, the dimensions adjust and all start points are changed to 0,0 ucs of the drawing. We are currently using AutoCAD MEP 2008.
Any help would be greatly appreciated.
Thank you.