Dimension / Symbol Gap

[JPM73]

Hi NX'ers,

I have handful of dims & want to clean up the drawings so that I don't have lines over lines. If I recall correctly in NX 6, there was a symbol to put gaps on dimensons.

Now, that I'm on NX 7.5, I can't find the symbol or feature. Perhaps, I don't have my sybmols loaded & if that's the case, where do I get them? If not, where's this feature?


Thanks

Jason M.
Unigraphics NX Designer

 

[JohnRBaker]

It's still there. Just go to...

Insert -> Symbol -> User Defined...

But make sure that you are using a Role with 'Full Menus'.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[JPM73]

Hi John,

Thanks for the info. There's to many symbols that look alike & obviously had the one one.



Jason M.
Unigraphics NX Designer