Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dimension witness line referencing centrelines not objects

Thread starter Hayden
Start date Jun 24, 2004

Status: Not open for further replies.

Jun 24, 2004

Hayden

Mechanical

Hi all,

Heres the deal;

I've got a few plates to model and draw with loads of holes in them. By company standards I HAVE to dimension each of these holes using centrelines and standard dimensions (not ordinate or hole tables).

Is there a way that I can automatically make the witness lines go to the ends of the centrelines NOT the hole centres themselves?

Thanks for any help,

Hayden