Dimensional Tolerance on 6061 T6511

[pdybeck]

Can anyone give me the dimensional tolerance on a Alumiunum 6061 T6511 Flat bar 2" Wide X 5/16" Thick? I have a set of ASTM standards and am using ASTM B221 to spec the material. ASTM B221 refers to ANSI H35.2 for size tolerances. I do not have the ANSI standard for this. Can anyone help me out? Thanks.

Pete Yodis

 

[Goahead]

A table on thickness tolerances can be found at

http://www.luminum.com/

under engineering data

http://www.welding-advisers.com/

 

[pdybeck]

Goahead,

Thanks for the reply. Do you know if the tolerances listed on that site are characteristic of ANSI H35.2 as referenced from ASTM B221? I did not find any mention on the site of adherence to any particular specification regarding tolerances, just a general statement; "tolerances are based on published standards used throughout the industry."