Dimensioning drawing|Break lines 1

[Nella95]

When dimensioning a drawing, you can set the default gap between dimensions. Is there a way to create a gap between 'note' callout arrows, and dimensions?

SW Premium 2011
64 bit SP4.0
Intel Xenon X5650 @2.67GHz
2.66 GHz 11.9 GB of RAM

 

[kellnerp]

Don't think so. Is this in any standard like ANSI?

TOP
CSWP, BSSE

http://www.engtran.com

http://www.niswug.org

http://www.linkedin.com/in/engineeringtransport

Phenom IIx6 1100T = 8GB = FX1400 = XP64SP2 = SW2009SP3
"Node news is good news."

 

[Nella95]

Uhh...'no' - it's not a an ANSI standard. I was just looking to make the note 'arrow' gap the same as the dimension line gap.

SW Premium 2011
64 bit SP4.0
Intel Xenon X5650 @2.67GHz
2.66 GHz 11.9 GB of RAM

 

[kellnerp]

SW tends to follow the major standards. So a company standard is not likely to be followed.

TOP
CSWP, BSSE

http://www.engtran.com

http://www.niswug.org

http://www.linkedin.com/in/engineeringtransport

Phenom IIx6 1100T = 8GB = FX1400 = XP64SP2 = SW2009SP3
"Node news is good news."

 

[CorBlimeyLimey]

Nella,

Submit an ER if this is important to you or your company.
If the option is available for dimensions, it does make sense to have the same/similar option for notes.