Dimensioning from hole to hole-compound radius

[aldumoul]

I am looking to dimension to the start point of the holes to each other from the face of the radius via a drawing. I can get it close, but, it's not good enough because it's a gauge.

Thanks,
Alan

 

[ctopher]

I'm not understanding the question.

Chris, CSWA
SolidWorks 14
ctopher's home
SolidWorks Legion

 

[aldumoul]

I am looking to get this dimension on a drawing. Not sure how to orientate the drawing to accommodate this.

Alan

 

[SBaugh]

You might try placing a sketch in the model and inserting the model item into the drawing, if the holes were not conceived by a sketch that has the dimensions already like that.

Regards,

Scott Baugh, CSWP

http://www.SuperATV.com

GEASWUG Greater Evansville Area SWUG Leader

http://www.scottjbaugh.com

"If it's not broke, Don't fix it!"

faq731-376