Dimensioning Scheme

[TCGT]

At this time when I have a dimension where the minimum value is on the left side and the maximum value is on the right, I would like to change it to where the maximum value is over the minimum value. I know this can be probably changed in the drawing setup file but I don't know where the command is.

Currently, my dimensions look like this:

15.991-15.994

And I would like to have the dimension look like this:

15.994
15.991

How can I change this setting?

Thanks for your help.

 

[robertib]

The option is in the drawing setup file

symmetric_tol_display_standard std_asme

 

[TCGT]

Thanks for the reply Robert.

I tried modifying the symmetric_tol_display_standard options and it didn't seem to change anything. When the tolerance was shown as 15.993+/-.002, those settings did make a change; however, when the tolerance was displayed as 15.991-15.995, the settings did not change the display.

Do you have other suggestions I can try?

 

[robertib]

Here is the drawing.dtl file I use, which does allow the setup you want.

 

[metalonis]

What version of ProE is being used? This oprion might not be available in older versions.

 

[TCGT]

The version of ProE I am running WF 2.0.