robcp
Automotive
- Jul 28, 2004
- 41
Hello,
I have changed the scale of the view from 1:1 to 1:2, but the dimensioning has been effected. I cannot place the dimension of the hole where I would like , I am not allowed to extend the dimensioning line. If I change the scale back to 1:1 everything works fine.
How can I fix this issue?
Thank you.
I have changed the scale of the view from 1:1 to 1:2, but the dimensioning has been effected. I cannot place the dimension of the hole where I would like , I am not allowed to extend the dimensioning line. If I change the scale back to 1:1 everything works fine.
How can I fix this issue?
Thank you.