Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

DIN 509 Forms and dimensions of undercuts

Status
Not open for further replies.
ardenum

ardenum

Mechanical
Feb 14, 2022
8
Hey guys,

Does anyone know if there's an automated tool in nx or a 3rd party plugin that you can use to make these undercuts? Drawing them by hand for each corner seems a bit...excessive

Many thanks!
 
Status
Not open for further replies.

Similar threads

moog3
  • Locked
  • Question
scaling dimensions
Replies
3
Views
412
moog3
moog3
MANox
  • Locked
  • Question
Number of holes in Hole and thread callout
Replies
0
Views
1K
MANox
MANox
yy912
  • Locked
  • Question
How to reattach dimensions for extracted geometry?
Replies
5
Views
452
TCS153518
TCS153518
Jashe
  • Locked
  • Question
Flaw with Relax Relations/Dimensions
Replies
0
Views
255
Jashe
Jashe
E
  • Question
Direction of an Offset Curve
Replies
0
Views
1K
ErkiPerki
E

Part and Inventory Search

Sponsor

Back
Top Bottom